Choosing Parquet: Wood Species, Construction Types and Finishes

Few materials change the feel of a room like a wooden floor. Parquet is warm underfoot, ages well and can last for generations if it is chosen and laid properly. The choices can be confusing, though, from wood species and board types to patterns and surface finishes. Here is an overview of what matters most.

Solid or engineered?

The first decision is the construction of the boards.

  • Solid parquet is made from a single piece of wood throughout its thickness. It can be sanded and refinished several times over its life, depending on how much wood is above the tongue and groove.
  • Engineered parquet has a top layer of hardwood glued to a base of other wood layers or boards. The layered build makes it more dimensionally stable, which means it moves less with changes in humidity and temperature.

Engineered boards are often recommended for floors with underfloor heating and for large, open areas, because of that stability. How many times they can be refinished depends on the thickness of the top wear layer, so ask about it when comparing products.

Wood species and grading

Oak is the most common choice for parquet in this part of Europe, and for good reasons: it is hard enough for everyday use, widely available and takes oils, stains and lacquers well. Ash, beech, maple, walnut and various other species are also used, each with its own colour, hardness and character.

Some practical points:

  • Harder woods resist dents better, which matters in kitchens, hallways and homes with pets.
  • Beech is known for reacting more strongly to changes in humidity, so it needs a stable indoor climate.
  • Wood colour changes with light over time. Some species darken, others lighten.

Within a species, boards are sorted into grades. A calmer grade has fewer knots and less colour variation, while a more rustic grade shows more knots, sapwood and natural marks. Neither is better; it is a question of the look you want and, often, of budget.

Laying patterns and methods

Parquet can be laid in simple parallel rows, in classic patterns such as herringbone or chevron, or in more elaborate designs. Patterns add character but take more time to lay and generally create more offcuts.

The two main installation methods are:

  1. Glued down to the subfloor, which is common for solid parquet and patterned floors. It gives a solid feel and good heat transfer with underfloor heating.
  2. Floating, where boards are connected to each other and lie on an underlay without being fixed to the subfloor. This is quicker and is used with many engineered products.

Whatever the method, the subfloor must be flat, clean and dry. Laying wood on a screed that still holds too much moisture is one of the most common causes of later problems, such as gaps, cupping or boards lifting. The moisture of the screed should be measured before installation, rather than estimated from the calendar.

Oil or lacquer?

The surface finish protects the wood and shapes how the floor looks and feels.

  • Lacquer forms a protective film on the surface. It is easy to clean and resists stains well. When it wears through, the usual repair is to sand and relacquer a larger area.
  • Oil soaks into the wood and gives a more natural, matt look. Oiled floors need regular care with suitable products, but worn areas can often be refreshed locally without sanding the whole floor.

Factory-finished boards arrive already oiled or lacquered, so the floor can be used soon after installation. Unfinished boards are sanded and finished on site, which allows a perfectly flat, uniform surface and a custom colour.

Parquet and underfloor heating

Wooden floors can work well with underfloor heating, but not every product is suitable. Check that the manufacturer approves the boards for heated floors, keep the surface temperature within the limits they specify, and follow the correct start-up procedure for the heating before laying. Thinner, engineered boards glued to the screed generally conduct heat better than thick floors on an underlay.

Parquet work is one of the finishing services Construction S carries out in renovations and new homes in Slovenia and Croatia. If you are choosing a wooden floor, contact us and we will help you find the right option for your rooms.

en_USEnglish

Privacy