When the carpet or old linoleum comes up during a renovation, there is often a wooden floor underneath. It may be scratched, stained and grey with age, but in many cases it can be brought back to life. Restoring an existing floor keeps the character of the house and the material that is already there. Before deciding, though, it is worth judging honestly what condition the floor is in.
How to judge whether a floor can be restored
Start by looking at the floor as a whole and then at the details.
- Structure: Does the floor feel solid, or does it bounce or sag in places? Movement can point to problems with the joists or the subfloor below, which must be dealt with first.
- Board thickness: Sanding removes wood. Look at a board edge, for example at a threshold or where a board is loose, to see how much wood remains above the tongue and groove.
- Damage: Scratches, worn finish and dull patches are normal and usually disappear with sanding. Deep burns, large cracks and rot are harder to fix.
- Moisture: Dark stains, soft areas or a musty smell can indicate past or ongoing moisture. The source needs to be found before investing in the floor.
- Insects: Small round exit holes and fine wood dust may be a sign of wood-boring insects. Ask for an assessment before deciding.
If the boards are sound and thick enough, restoration is usually possible and often well worth it.
What sanding and refinishing involve
Professional floor sanding is done in several passes, starting with a coarse abrasive to remove the old finish and level the boards, then moving to finer abrasives for a smooth surface. Edges and corners are sanded with a separate machine. Between passes, gaps and small cracks can be filled, often with a mixture of wood dust and filler, so the colour stays close to the boards.
After sanding comes the finish, usually oil or lacquer, sometimes with a stain to change the colour. Several coats are applied, with drying and sometimes light sanding in between.
A few things homeowners should know before the work starts:
- Rooms must be completely empty, and other trades should be finished in that area
- Sanding creates dust, even with good machines and dust extraction, so it is best done before final painting
- The room cannot be used while the finish dries and cures, and heavy furniture should wait until the finish is fully hardened
- Old nails and screws must be set below the surface, or they will damage the sanding machine and the floor
Common repairs on old floors
Restoration is often more than sanding. Typical repairs include:
- replacing individual damaged boards or parquet blocks with matching reclaimed or new wood
- refixing loose boards and blocks that move or rattle
- fixing creaks by securing the boards to the joists or subfloor
- dealing with gaps, which can be filled if they are small, while large gaps may require boards to be relaid
- repairing areas that were cut open in the past for pipes or cables
Finding matching wood can be the hardest part, especially with old species, sizes or patterns. Sometimes boards are taken from a less visible place, such as inside a built-in wardrobe, and used where they are seen.
When replacement is the better option
Restoration is not always the right answer. Replacement may make more sense when:
- the boards have been sanded so many times that little wood remains above the tongue
- large areas are damaged by rot, insects or repeated water leaks
- the subfloor or joists need major repairs anyway
- you plan underfloor heating or new insulation under the floor
- the floor levels need to change significantly, for example to match new rooms
Even then, good old boards can sometimes be lifted and reused in another room or as wall cladding, which keeps the material in the house.
Construction S carries out parquet work, including sanding, repairs and new floors, as part of renovations in Slovenia and Croatia. If you have discovered an old wooden floor and want to know whether it can be saved, get in touch with us.