New windows are one of the most noticeable improvements you can make to an older house. Rooms become quieter, draughts disappear and the house is easier to heat. At the same time, replacing windows in an old building is not just a matter of swapping one frame for another. The way the window is installed and how it changes the behaviour of the walls around it matter as much as the product itself.
When is it time to replace windows?
Old windows can sometimes be repaired rather than replaced, especially solid timber frames that have been looked after. Replacement usually makes sense when:
- frames are rotten, warped or no longer close properly
- you feel strong draughts even when the windows are shut
- glass fogs up between the panes, which means the seal of the glazing unit has failed
- condensation and mould regularly form around the frames
- you want better sound insulation or security
If the house has historic value or protected status, there may be rules about what the windows can look like. In that case, check with the relevant authorities before ordering anything.
Choosing frames and glazing
The most common frame materials are timber, PVC, aluminium and combinations such as timber with an aluminium outer cladding. Each has its strengths:
- Timber is warm, repairable and suits older buildings, but needs periodic maintenance of the surface.
- PVC is low maintenance and widely used, with many profiles and colours available.
- Aluminium is strong and allows slim frames and large glazed areas.
- Timber with aluminium cladding combines a timber interior with a weather-resistant exterior.
Glazing today is usually double or triple. Triple glazing generally insulates better but is heavier and more expensive, and the benefit depends on the orientation of the window and the rest of the building. Ask for the thermal values of the whole window, frame included, not only of the glass, and compare offers on the same basis.
Installation is where most problems start
Even an excellent window will perform badly if it is poorly installed. The joint between the frame and the wall is the critical point. A good installation keeps that joint airtight on the inside, lets moisture escape towards the outside and is insulated in between. Simply filling the gap with expanding foam and covering it with plaster is a common shortcut that can lead to draughts, damp and mould at the edges of the window.
In old houses, walls are rarely perfectly straight and window openings are not always square. Measure carefully, and expect some repair to the reveals, the inside and outside surfaces around the opening, after the old frames come out. Window sills, both inside and outside, should be planned together with the window so that rainwater is led away from the wall.
New windows change how the house breathes
Old windows usually let in a lot of air through gaps in the frames. That is uncomfortable, but it also means that moist indoor air was constantly being replaced. Once tight new windows are fitted, that uncontrolled ventilation stops. If the habits in the house do not change, humidity can build up, and condensation may appear on the coldest surfaces, often wall corners or the reveals around the new windows.
To prevent this:
- Ventilate rooms regularly, especially kitchens, bathrooms and bedrooms
- Consider trickle vents in the frames or a mechanical ventilation system
- Make sure the reveals and wall junctions are well insulated, so they do not become cold spots
- Think about the walls themselves: if the windows are much better insulated than the walls, the walls become the coldest surface in the room
This is why window replacement is often best planned together with other improvements, such as insulating the façade or renovating the heating system.
Timing and the order of work
If you are doing a larger renovation, windows usually go in after demolition and structural work, but before plastering and finishing. That way the building can be closed, interior work can continue in any weather and the reveals can be finished neatly with the rest of the walls. If you are planning external insulation later, discuss the window position in the wall with your contractor now, because it affects how well the two can be joined.
Construction S carries out renovations of houses, flats and business premises in Slovenia and Croatia, including installation work and exterior elements. If you are thinking about new windows as part of a wider renovation, contact us and we will help you plan the details.